10-10-2012 04:11 AM - edited 07-03-2021 10:48 PM
Hello all,
My customer has upgrade his 4506 from 6L-E to 7L-E 10GE
Ever since then if he run the command
show dot1x interface gigabitEthernet x/x details
some information are not been displayed (below are missing information)
PortControl =
ControlDirection =
HostMode =
Is this intensional or do I need to kick this to TAC?
or has someone come accross this before?
thanks in advance
Lancellot
10-11-2012 04:14 AM
hi all,
just a bit more info, based on cisco command reference
if you do
Switch# show dot1x interface fastethernet6/1
Dot1x Info for FastEthernet6/1
-----------------------------------
PAE = AUTHENTICATOR
PortControl = AUTO
ControlDirection = Both
HostMode = MULTI_DOMAIN
ReAuthentication = Disabled
QuietPeriod = 60
ServerTimeout = 30
SuppTimeout = 30
ReAuthPeriod = 3600 (Locally configured)
ReAuthMax = 2
MaxReq = 2
TxPeriod = 30
RateLimitPeriod = 0
Dot1x Authenticator Client List
-------------------------------
Domain = DATA
Supplicant = 0000.0000.ab01
Auth SM State = AUTHENTICATED
Auth BEND SM Stat = IDLE
Port Status = AUTHORIZED
Authentication Method = Dot1x
Authorized By = Authentication Server
Vlan Policy = 12
Domain = VOICE
Supplicant = 0060.b057.4687
Auth SM State = AUTHENTICATED
Auth BEND SM Stat = IDLE
Port Status = AUTHORIZED
Authentication Method = Dot1x
Authorized By = Authentication Server
Switch#
ll the above should be displayed, however this is missing from the customer device any help or advice?
thanks in advance
Lancellot
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide