Multiples VLAN WLC 9800 CL

[stobar1101]

Hello guys,

I am running into a problem in my WLC 9800 CL, I cannot pass multiple VLAN traffic, I have configured the Vswitch as a trunk and activated promiscuous mode.

Switch Port Configuration

interface Port-channel15
description ** Port-Channel to UCS-6324-A **
switchport trunk native vlan 99
switchport trunk allowed vlan 10,70,90-99,800-900
switchport mode trunk
end

interface TenGigabitEthernet3/0/2
description ** Port-Channel to UCS-6324-A **
switchport trunk native vlan 99
switchport trunk allowed vlan 10,70,90-99,800-900
switchport mode trunk
channel-group 15 mode active
end

interface TenGigabitEthernet4/0/2
description ** Port-Channel to UCS-6324-A **
switchport trunk native vlan 99
switchport trunk allowed vlan 10,70,90-99,800-900
switchport mode trunk
channel-group 15 mode active
end

Attachment configuration of WLC 9800 CL

[Jurgens L]

Did you test without Port-Channel?

[stobar1101]

If I tried it without Port Channel and the behavior is the same.

[Flavio Miranda]

Hi

 I´d not add vlan 99 on the command "allowed vlan" as you added it as native.  I´d try different mode for port-channel rather than active, just to make sure.

Take a close look on the VM config. Here a detailed guide:

http://www.wifireference.com/2019/08/24/cisco-catalyst-9800-cl-deployment-guide/ 

-If I helped you somehow, please, rate it as useful.-