NCS SNMP Community String

[da.newman]

Is possible to monitor an NCS servers status via snmp (ie memory usage, disk space etc)? I've been through the NCS server setup and I can find all the references for "SNMP credentials" but the NCS server appears to only use these from rouge AP detection. It there a specific location to set the NCS Server SNMP community string to allow polling of the server status via snmp?

[Amjad Abdullah · Accepted solution]

From the CLI you need to configure the SNMP configuration.

snmp-server host version v2c

snmp-server community ro

see this:

http://tiny.cc/k52iqw

Regards,

Amjad

Rating useful replies is more useful than saying "Thank you"