Normal Ethernet Cat5e cable for In-Line Power of Aironet 350 Bridge ???

[fkseow]

Anyone please confirm that can I use the normal Cat5e cable for the use of in-line power on Aironet 350 Bridge ?

I was told by my Wireless vendor that I cannot use the normal type of Cat5e cable instead I must the one supplied by Cisco. Is this true and correct ?

Is there any cable length limitation on the Cat5e (other than must less than 100m) ?

Please help out.

[mococa]

It´s not necessary to use a special cable, Cat5 cable is enough.

[jimmy.gibson]

It's true. I used a 100 ft homemade cat5 cable to power up my AP350 and it worked fine.