04-12-2019 01:55 PM - edited 07-05-2021 10:15 AM
I am trying to do an inline upgrade from PI2.2 to PI3.0. I copy the upgrade file to defaultRepo and start the ujpgrade process. and verify the MD5 and SHA512 Checksums. When I start the install, I get the following:
Initiating Application Upgrade...
Stage 1 of 7: Transferring file ...
-- complete.
Stage 2 of 7: Unpacking file ...
% Unable to unbundle the package. Package may be corrupt or there is not enough disk space
I verify the MD5 and SHA512 Checksums and they are correct.
What disk space might be the issue. Can anyone advise what I should look at next. TIA
04-12-2019 02:28 PM
Is it appliance or VM? If its appliance is it Gen 1 or Gen 2 ?
04-12-2019 02:35 PM
It a physical appliance, Gen 1. The document I have indicates I can do an inline upgrade from 2.2 to 3.0 on a Gen1 appliance.
Thanks for your help.
04-12-2019 03:02 PM
Version 3.0 is not supported on Gen 1 appliance . Ref Prime 3.0
04-12-2019 06:24 PM
I understand Cisco will not support PI 3.0 on Gen 1 appliance. However it can be done. So I was looking for info from someone who has performed the upgrade. Thanks again for your help.
04-12-2019 10:58 PM
- #wasteoftime
M.
04-15-2019 05:03 AM
04-30-2019 07:20 AM
Check this once please Disk out of Space issue
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: