cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
236
Views
0
Helpful
1
Replies
Highlighted
Beginner

Prime Infrastructure 3.3 won't display MESH Link SNR

I have added my MESH AP's to the map and the MESH links appear on the map as 0 SNR.  I can run the link test Parent-> Child and vise-versa and SNR os good.  If I go to Monitor->Access Points-><AP Name>-> Link detail, everything is zeroed out.  I do have "Refresh from Network" enabled.  Am I missing a configuration parameter somewhere?

Everyone's tags (3)
1 REPLY 1
VIP Advocate

Re: Prime Infrastructure 3.3 won't display MESH Link SNR

Which software is running on your APs? There were some versions affected by an SNMP bug which reported 0 as signal strength.
The latest versions of 8.2, 8.3 and 8.5 should have fixed this issue.
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards