04-25-2006 06:01 AM - edited 07-04-2021 11:58 AM
Hi everyone,
I use Cisco AP1131 in a bulding. I have installed and cofigured several AP two months ago.
Yesterday, 2 AP had a fault : "AP Memory utilization is Overloaded (97%)"
I don't undestand why and I can't find the reason which could have lead to this fault...
Have someone been faced with this problem and have managed to solve it?
I read a lot of documentations but it didn't help me...
Thank you for your help!
Khay
04-25-2006 11:06 AM
Fault description and recommended action is explained in the Fault FAQs: http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/ts_gd/faults.htm
04-25-2006 11:41 PM
Hi,
I have already read this page but it didn't help me a lot...
"Verify that the fault threshold is set correctly.
If the threshold is set correctly, review your network to determine the action necessary to clear the fault condition. "
The fault threshold is set correctly...
I have to review now my network but how? which aspects should I look for?
I suspect that the fault results from an attack, like DoS but how could I verify this assumption ?
Thanks U by advance for your help...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide