cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
412
Views
0
Helpful
3
Replies

Radius response failure

johnmdolan
Level 1
Level 1

We have 2 5508's, 2 7500's, and 12 4400 series pan controllers.  All but one is getting flooded with radius failed to respond.  We have three radius server configured for AD authentication.  One for BYOD, one for machine authentication and one for group authentication.  I have not changed anything on the WLC's and its been fine for months.  This started last week and there are clients getting timeouts when connecting.

3 Replies 3

Mark Jensen
Level 1
Level 1

Look at this link, it may help.

 

https://supportforums.cisco.com/document/89386/troubleshooting-radius-issues

 

or the attached doc

abwahid
Level 4
Level 4

Hi

Go through the below link and make sure, what are the prerequisites for radius server to reorder.

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_usr_rad/configuration/15-sy/sec-usr-rad-15-sy-book/sec-rad-reorder-fail.html#GUID-9754C291-4466-4CE7-AC3C-CF246E83DFD5

Abha Jha
Cisco Employee
Cisco Employee

posted below ans :-

 

Increase the radius timeout value.

collect debug client from WLC

Also capture the wireshark messages between WLC and radius.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: