cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
326
Views
0
Helpful
4
Replies
Highlighted
Beginner

Reboot WLC using Cisco Prime

Is there a way to reboot a wireless controller in Prime and schedule it to reboot. I know you can go Configuration > Network Devices > Select WLC > Reboot Controller/s - but that doesn't allow me to schedule anything. I was therefore thinking I would have to use some sort of template but not done this before. Can anyone advise?

Everyone's tags (2)
4 REPLIES 4
VIP Advisor

Re: Reboot WLC using Cisco Prime

 

From Prime :

Configuration / Templates / Features & Technologies

 

 

BB
*** Rate All Helpful Responses ***
Hall of Fame Community Legend

Re: Reboot WLC using Cisco Prime


@Jay_F wrote:

Is there a way to reboot a wireless controller in Prime and schedule it to reboot.

Keep it simple:  reset system at <YYYY-MM-DD> <HH:MM:SS> image <no-swap | swap> reset-aps [save-config]

Beginner

Re: Reboot WLC using Cisco Prime

Hi Leo Laohoo, are you able to confirm if I click deploy it will allow to select specific controllers to push the template out to ?
Beginner

Re: Reboot WLC using Cisco Prime

So by selecting that I get:

#MODE_ENABLE
write memory
#INTERACTIVE
reload <IQ>configuration<R>no<IQ>Proceed<R>yes <timeout>${waittimeout}</timeout>
#ENDS_INTERACTIVE
#MODE_END_ENABLE

Does this apply to a 2504 WLC ? or do I have to amend this to something like: reset system at
Also, slightly confusing, I haven't clicked it yet but there is a 'Deploy' button, do I assume after I click that I can select a specific wireless controller to push this out to - I was concerned it might push a reboot out to all WLC's if I clicked 'Deploy'.
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards