cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
288
Views
0
Helpful
2
Replies
Beginner

Task 2: Configuring NADs for Cisco ISE

hi all

I am trying to study Unified access Bootcmap lab in my office. i have made my lab but i'm in the trouble for NAD's
Boot Camp Lab Guide already configured. so i couldn't know how configuring in my lab.
as you can in the figure that i want to know. the whole configuration anybody know about that?

i atteched word file. this is unified access bootcamp 110 page

2 REPLIES 2
Cisco Employee

check the following links for

check the following links for NAD(Switch/WLC) configuration to support ISE

http://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise/design-zone-security/howto_10_universal_switch_config.pdf

http://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise/design-zone-security/howto_11_universal_wlc_config.pdf

VIP Mentor

HiIf you want simply add a

Hi

If you want simply add a NAD to your ISE you can do that via below

Administration > Network Resources > Network Devices

In this example I have configured 3850 switch as NAD with ISE. Hope that gives you some guidance

http://mrncciew.com/2013/12/06/wlan-config-with-3850-part-2/

 

HTH

Rasika

**** Pls rate all useful responses ****

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards