I have a location with a 5508 wireless controller and many 3502, 3602 and 3702 wireless access points. All of our access points use vlan 2, so I include the command SWITCHPORT ACCESS VLAN 2 on any port connected to an access point. All of this has been working fine.
Here's my issue --- I just added our first AIR-AP2802I-B-K9 access point, with the intention to have 2 gigabit Ethernet connections to the AP, so we have more bandwidth. I can make it work using just the ETHERNET port, but I have unsuccessful using the AUX port. Here's my layout...
Cisco WS-C3650-24PS switch. Switch Port 23 is connected to the 2802's ETHERNET port, and Switch Port 24 is connected to the 2802's AUX port. Right now, I have switch port 24 SHUTDOWN. If I do a NO SHUT on the port, the access point will disappear from the 5508 GUI, and not come back until I SHUT port 24 again.
It is my understanding that I need to create a Channel-Group and enable LAG to get this working. Does anyone have a step-by-step on how to do this? I have some reference material but I think I am missing steps. Seems like this should not be that hard.
Thanks everyone --- Walter
My boss bought this dual-port AP specifically to see if we want to move in this direction... we support over 5000 Chromebooks in our buildings. I will reach back out to our local Cisco dealer. Thank you.