The built-in Catalyst 9800 WLC TACACS+ usernames on its webUI and webUI admin access privilege question.
Dear Experts, I have two questions about Cat9800 WLCs TACACS+ admin access configuration.
1. Once 9800 is configured to do TACACS+ for its webUI admin access, no matter if logging with WLC local admin accounts or AD accounts, there are always two usernames, "copyrightbanneruser" and "webuiuser", attempting for Authorization. No logs shows these two usernames ever tried Authentication. Has anybody seen the this?
2. For TACACS+ admin access, based on my tests, it seems for the webUI TACACS+ admin access, Cat 9800 can only take one priv-lvl response from ISE, the value could be either =1 or =15. Unlike for its CLI admin access, it can take response with both "priv-lvl = 1" and "max_priv_lvl=15". Is there a way to configure the webUI to have the admin log in on webUI as priv 1 initially, then to be elevated to priv 15 if needed?
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?