WAP Lifecycle Question

[reepat]

Is there a method to wipe many AP's after a life cycle? 

Say you have 500 AP's to wipe the entire configuration on after a life cycle, what's the most efficient method?

[Sathiyanarayanan Ravindran]

Hi Reepat,

Using clear all config option you can remove the configurations of those AP. 

Refer the configuration guide Reset the CAPWAP Configuration on APs

[reepat]

How would you apply this command to 40 AP's that are on the same switch as the WLC?

[Sathiyanarayanan Ravindran]

Hi Reepat,

You have to get the AP name using the command grep include "AIR-CAP702I-Z-K9" "show ap summary" (model number will change based on your requirement)

Then you can use notepad++ to create this command for all the APs. then you have to login CLI of the WLC and need to run the command.

(Cisco Controller) >clear ap config <Cisco AP>