11-28-2013 10:19 AM - edited 07-04-2021 01:20 AM
hello
i have a question
i config a WLC 5508 and one LAP join it
now i connect the SSID
i can get the right ip address
i can ping another address
at the same time i can ping WLC and telenet WLC port 443 is OK
but i cant access the WLC web page
if i connect the local nic (....RJ-45 to my PC...i don't known how to say.....)
i can access WLC....
who can help me..?
Solved! Go to Solution.
11-28-2013 11:05 AM
This is the default behavior & it blocks WLC mgt access via wireless.
If you want to change this, you can go in GUI "Management -> Management Via Wireless -> enable "
Keep note that then all wireless users can get into this page (without knowing password they cannot do much), & as a security measure by default this is blocked.
HTH
Rasika
**** Pls rate all useful responses ****
11-28-2013 11:26 AM
Just adding to Rasika...
If u can telnet WLC then please run this command to access via GUI.
config network mgmt-via-wireless enable
config network mgmt-via-dynamic-interface enable
Regards
11-28-2013 11:05 AM
This is the default behavior & it blocks WLC mgt access via wireless.
If you want to change this, you can go in GUI "Management -> Management Via Wireless -> enable "
Keep note that then all wireless users can get into this page (without knowing password they cannot do much), & as a security measure by default this is blocked.
HTH
Rasika
**** Pls rate all useful responses ****
11-28-2013 05:25 PM
rasikanayanajith
thanks very much!
the WLC is not in the same subnet with wifi , so i can use ACL deny access but administrator wifi....
11-28-2013 11:26 AM
Just adding to Rasika...
If u can telnet WLC then please run this command to access via GUI.
config network mgmt-via-wireless enable
config network mgmt-via-dynamic-interface enable
Regards
11-28-2013 05:27 PM
hi sandeep
thanks you for you reply
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: