Just starting to test this out and configure everything. ACS is setup with the controllers and my test user. Using LEAP (802.1x). From the controller I can ping my ACS box and ping my access point. From the vlan that the access point is configured on I can ping to my ACS box. When I go to authenticate it fails. Check the failed attempts in ACS and there is no entry, which makes me think I'm not even hitting the box. Was thinking of putting a sniffer behind the ACS box, but will I see anything? Or will it be all encrypted? If there is anything I need to post here to get more help let me know. Thanks in advance.
Also, when I take off the security. I connect and can ping everywhere with no problems. One more thing that has me a bit confused is that with the controller set to broadcast the SSID in the WLAN it won't broadcast.... atleast not that I'm seeing. Thanks again.
To configure IP Address in AP
config ap static-ip enable AP-NAME IP-ADDRESS MASK GATEWAY
To configure AP Credentials for Telnet/SSH
config ap telnet enable AP-NAME
config ap ssh enable AP-NAME
config ap mgmtuser add username USERNAME password PASSWORD en...
We are unable to see the radios APs available... we connect direct to to the POE 110SG-24 ptos switch but its star blinking as it is running and suddenly blinking form red-blue-green-off .. .as we read it means it doesnt have enough power... b...
I want to reserve IPs which are got from dhcp server. My dhcp server is configured in cisco WLC-2504.
I can reserve IPs by mac binding in cisco 3850 switch. What is the procedure for WLC-2504. (
I've already issued "config network ip-mac-bindi...