I have a WLC 3504 and it works well with my first network attempt- I had set up a guest network. Clients connected to it receive an IP address and can access the internet. This network is isolated from our production environment, but was almost as easy as setting up a home router. Now I need to set up an internal network. I have created the SSID, and RADIUS is authenticating properly- I have no access to the networks I need though. The clients get IP addresses in the 10.10.30.0/24 range (Bottom of DHCP pool is 10.10.30.50). The first network I need to reach is 192.168.1.0/24. Do I need to define a network route on the WLC? None are currently defined. My service port is set to a fictional address. I have full control of the WLC and WAP's. My management port is actually on the 192.168.1.0/24 subnet. What do I need to do to get from 10.10.30.51 to 192.168.1.8, for example?
I could not post text below the pic for some reason. I will eventually want to be able to reach 192.168.3.0/24 from clients on the 10.10.30.0 network, but I am just trying to get 192.168.1.0/24 communicating properly first. Any ideas? I included a list of the interfaces and IP's on the WLC.
