WLC 5500 with multiple APs

[luisalviarez]

We have a WLC 5500 apliance, but i have a problem, the APs have a administrative IP in a diferent segment, only conected to WLC the AP have same segment of the management interface, the 5500 don´t have APmanager interface.

How configurate the WLC to conected and administrate all AP with different segment IP

Product Version.................................. 6.0.182.0

chasis:        AIR-CT5508-K9

[Stephen Rodriguez]

The 5508 does not need a separate ap manager ip, the management ip does both jobs.

Sent from Cisco Technical Support iPhone App

[luisalviarez]

how the management ip does both jobs, what is the configuration on WLC

[Stephen Rodriguez]

That's just the architecture of the 5508.  You don't need a seperate AP manager.

Cheers,

Steve

--

If  this helps you and/or answers  your question please mark the question as "answered" and/or rate it, so  other users can easily find it.

[Saurav Lodh]

For Cisco 5500 Series Controllers, you are not required to configure an AP-manager interface. The management interface acts like an AP-manager interface by default, and the access points can join on this interface.

[Amjad Abdullah]

You may check this article about the discovery process:

http://tiny.cc/lqu1zw

Now, with what Steve above is trying to say is that with 5508 the management interface itself is the AP manager interface (by default). so, management and ap-manager interfaces are merged into one interface with same IP address. You can change this behavior but this is the default.

The article will tell you what mechanisms can be used to direct the APs to join the WLC even if they are on different subnet.

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"