cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
555
Views
0
Helpful
2
Replies

WLC 5508 Mac Address Filtering - Filter By Partial Address?

AnthonyH
Level 1
Level 1

Hello,

 

This is probably not realistic, but I'm wondering if it's possible.  Using the WLC 5508, if I wanted to block an entire manufacturer's devices from connecting to a WLAN, is it possible to create a MAC address filter based on a manufacturer's MAC prefix?

 

 

Thanks in advance!

2 Replies 2

marce1000
VIP
VIP

 

 - Not possible

M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

ammahend
VIP
VIP

you can not using OUI, but you can using full 48 bit MAC address.

to deploy you follow the config guide here, its little old but you will be able to figure out.

 

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/91901-mac-filters-wlcs-config.html#conf

 

 

-hope this helps-
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: