Hello, I have doubts about my configuration on my Wlc2504.
I have only 2 interfaces:
1- interface management: vlan identifier untagged (0) 192.168.100.10
2- interface clients: vlan identifier 2 192.168.200.10
and 2 ssid:
management : associated to interface management (untagged - 0)
clients: associated to interface clients (vlan 2)
All the clients of SSID's client works fine but randomly I received a lot of reports that people connected to "management" SSID connect but they can't navigate. When it's happend, you are connected well but if you does a speed test all is 0 Mbps.I checked the DNS and dhcp and it's fine, it's something that happen randomly.
I though that maybe default vlan could be the reason of those issues and for that reason I decided to test adding a new vlan (vlan3) in my switch and I configured the port like this:
description "WLC01 Gi1"
switchport trunk allowed vlan add 2
switchport trunk native vlan 3
In the wlc2504 the config is:
vlan identifier: 0
But it happens the same...any idea?
Finally I could analyze it. I think that is the next:
Security: WLAN may be using management vlan. It is recommended to never set SSID into management vlan, even for anchor scenarios.
I think that I have another interface, associated it vlan3 and delete all configuration of management's interface.
Is it correct?