When I back up my configs I am now seeing this message against some devices. I have checked that I only have 580 devices and the limit is 2500 (ish). I have also set up smaller jobs below the 500 collection limit to cover that possibility, still the same on smaller jobs... Any clues??
There typically isn't a limit to the number of devices in a archive job. In order to debug this scenario further, could you please enable the 'debug' mode for Archive module(as mentioned in the last part of this
message) and then try the following:
i) Try an archive job with a single device which is reporting error.
ii) If the above job succeeds increase the count of devices to multiples of
100(say 100, 200, etc.) in the job.
iii) Again, if the above job succeeds, please increase the count of devices
in the job to whatever level causes the issue and run the job again.
Once the jobs are finished, save the jobvm.log(Admin-->Appliance-->View Log
File) to desktop and upload it here, and I'll take a look.
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 18.104.22.168, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...