cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
510
Views
0
Helpful
1
Replies

WLSE 2.12 & Inventory

gauthrayj
Level 1
Level 1

Hello,

I run WLSE 2.12u with 1000+ AP managed (AP1231 & AP1131) with different IOS version. Some AP are in standalone mode, somes are with WLSM and other with AP-WDS devices.

I have a lot a of "Device Relationship Inventory" that are run very often :

- one or two "Device Relationship Inventory" every 10 min

- 3 "Device Relationship Inventory for WAP-WLSM" (our WLSM device) every 10 min

- 3 "Device Relationship Inventory for WAP-WDS" (our AP-WDS devices) every 10 min

I don't know what are these inventory, why we have so many inventories and why it runs only on WDS devices.

If someone could help me...

Thank You,

Regards

1 Reply 1

pradeepde
Level 5
Level 5

I think the network has been segmented into different zones and each zone has its own device lists which is stored under the device relationship inventory. Is this a new setup? Was somebody managing this if it is a old setup.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card