Wireless - Small Business

I have a cluster of 5 AP541Ns. I accidentally started the auto update of IP addresses based on reduction of interference, and it changed the wireless channels on all of the APs. I disabled it, but he channel settings did not change.Now if I remember ...

Hi everyone,I'm an owner of a Linksys E4200 and a Cisco WAP200. I have a Linksys E4200 fully working and no problems on that. But I wanted do have wireless signal all over my house. So I've bought the WAP200 to be my repeater.I've selected Repeater f...

Hi is there any management software available to manage 5 or so AP541N running across a WAN. Eg we have a couple of VAP's setup on each access point 1 for staff and 1 for guests. I would like to be able to change all the WPA Personal guest access pas...

How do we begin troubleshooting a wireless device accessing the network that a user is complaining slow accessing network recources?We are getting complaints that it is slow, when connected to internet we get about 20 MB.There is only one user connec...

Hi,I just upload firmware1.0.1.10 on 2 WAP121. After the update and reboot, I was able to confirm the firmware version in the System Summary menu. The update is uneventful. However, the functions WDS Bridge and WorkGroup Bridge no longer works on two...

Hi All, and thanks in advance for any and all support I can get on this issue.My company has an RV180W Router, a SGE-2000 Managed Switch, and a WAP321 Wireless Access Point. I have about 12 users on a Windows 2003 Server Standard, completely updated....

I have an issue were I have a wrvs4400N V2 sending out a wireless signal. About 150 feet away I am trying to install a WAP4410N and utiliz the cient/repeater mode in the AP. I log into the Access Point and on the AP tab i choose the client /repeater ...

Hi Team,you can reduce the noise associated with repetitive error messages? Sometimes the error message in question is present with high frequency at various series of small business AP although more than a "error" can be considered a "notice"; I do ...

Hi,we have got 3 Cisco APs 541N with firmware version 9.2.2 and want to set up the cluster function for those APs.Here is the problem:Before enabling the cluster you can ping all three APs located in the same local network with a delay of 1ms or belo...

Antennas were set aside prior to device installation, and now can't be found. Can they be ordered as a replacement kit?

Hi,I just installed a WAP321. I literally configured a test SSID, implemented WPA Personal security, and could not get an iPad or Blackberry to associate with the network. The error message that appears in the Blackberry is "EAP Authentication Failed...

Please I need some help to set my wireless network with those equipments.I have the E4200 with RE1000 in my old place, with no problems. In my new place, there is a blind spot and I bought another RE1000 to use like a repeater of the first repeater (...