Hello!
This sticky-post will serve as a sign-post for incoming community members. Below you will find links to pages that you may find helpful.
Virtual Assistant- Discover support content and options for your gearSupport page index - Contains a ...
Hi guys,Can WAP200E repeat with other AP models? I think it should be working with other models as the signal should be the same in different APs. Is that correct ?Regards,Henry
My company recently installed 10 - 521 wireless access points, which are controlled by a 526 controller. The system replaced another vendor's 802.11b system already in place, so no survey was done. We are now getting complaints that the wireless co...
I am having some weird things happen...I have setup a WAP200E external w/o optional antenna and using (2) WAP200 internal units in separate buildings setup as repeaters. I have added a externalYagi 10Dbi directional antenna to both repeaters with sh...
I am working on a wireless network with a WAP200E Access Point and (2) WAP200 repeatersI installed the HGA9N (external omni-antenna) on the WAP200E and it did help improve the signal quite a bit.From the same remote location (100% metal building with...
I tried to upgrade a WET200 with the latest firmware following massive problems during setup (connecting to the wireless network was hit and miss and I couldn't get any traffic between wireless and wired). Using the config I began to upload the new f...
I have 2 new wap200e in bridge mode -- after setup and cold start, they talk to each other for about 4 or 5 minutes, then the wireless light on both goes out, and they will not talk to each other. Any Help?????ThanksBarry
Our WAP4410N also shipped with firmware version 2.0.0.5 and is experiencing most of the problems reported in these discussion threads. Keep in mind we have a very small branch office, and we use this as our only wireless AP. The configuration is ve...
Hi!A customer of mine bought an external antenna for WAP200G, HGA9N. This has obviously a N-connector, WAP200 does not. Is there a conversion availble for N connector? And is this antenna useable for the WAP200?
I noticed Cisco product sales support staff is pushing 2125 WLAN controller as great WLAN solution. They got me into considering one as something what will work just fine.I strongly disagree, this product is extremely poor design and it is missing gi...
Just bought 2 of these (wish I had seen this thread before). They shipped with the latest firmware already on them, so must be a very recent manufacture. I am having the exact same problems as above. It seems to be almost exactly 24 hours for me a...
Hi,I am using outdate version of firmware 1.2.8-ETSI, I only have problem with must power cycle sometimes, if we using with heavy transfer upload/download like torrent.my question, if i upgrade to latest firmware version 1.2.19 does it fix my problem...
Hey guys,I'm having a couple of issues with the 4410N. We are currently using the 4410N's as access points for our Blackberrys to use UMA.I currently have 4410N connected, I can connect WiFi through my blackberry and the UMA works. Now, I try to ping...
I recenty bought WAP4410N Wireless-N Access Point:Firmware: 2.0.0.5It has a feature I never saw in prior Linksys WAPs I bought in the past. That feature is "Wifi Protected Setup"! I have two questions about this feature:1) What is the purpose of the ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: