Wireless - Small Business

Hello,I have a Cicsco AP 541 and I would like to add another one into a cluster but I require assistance.Thank you.

Hello All,working with the RV180W and a Ubuntu server I have established a FreeRADIUS server and have it setup for PEAP authentication based on a users file with NTLM encrypted passwords.  This is working pretty well, however I have one problem.  My ...

I currently have a WRVS440N v1 working with a WET200 bridge, E1200 router (guest wireless vlan 2) and SLM208 trunking to the router.  I need to support another bridge location but the WET200 is EOL.  Looking to clean this up but I want to keep the 8 ...

Does anyone have any expericne using Chromecast with the Small Business WAP's? We have a cluster of 321 WAP's that seem to drop the Chromecast conenction every 2 minutes or so then re-establish then drop in 2 minutes, etc.. Thanks in advance.

I'm trying to configure a WAP321 so that I have the same SSID and WPA2 password on both the RV220W and the WAP321 so that i can reach all areas of my clients location.I am unfamiliar with the WAP321 so any help is appreciated.

                   I'm looking to upgrade my network as followsFrom WRVS4400N  ----------> WET200 - ClientsToRV180W ----------------------->WET200 - clients                              |                              |---------->WAP121/321 -- Switch ...

Hi,We have bought the Cisco Access Point Version "AP541N-K9-2.0" We are having the below issues while testing with the Access point1)Accounting-interim update request is not sent by the Access point for an active session2)Accounting stop request do n...

Hi..   We had bought the Access Point  "Version AP541N-K9-2.0(2)".We tested using the above Access Point by configuring a new ssid.We observed the follwing issues :1)Accounting-interim update request is not intiated from Access Point and couldnt find...

Enovironment     7) AP541N-K9-2.0(4) Clustered     2) SSID's on VLAN1     WPA/WPA2/TKIP/CCMPI am finding that wireless clients (Phones, Laptops, IPads, Tablets, Etc) won't connect and get an IP address.  They do authenticate with the wireless but nev...

HelloI have a WAP321. The unit hangs about on every day. Web interface and WLAN let not respond anymore. By a reset the unit will be back. I have put all unnecessary stale. Tracing the turned on, I can say nothing flashy.Martin

I have been setting up a WAP 321 which has been unable to retain it's settings across reboots.What I have found is that if I leave the Timezone set to USA (Pacific) the WAP 321 can be rebooted without losing config, but as soon as I set the timezone ...

Hi,We have a WAP321 WAP321-E-K9 V01 and it worked just fine for about 4 months but now for unknown reasons and not in a specific time, I doesn't let any devices to connect.For example (most often) at the 1st hour of work all 10 computer can connect w...

Hi, I'm using two WAP321 with 4 VLANSVLAN 100 - WPA PSKVLAN 101 - WPA RadiusVLAN 102 - open (captive portal)VLAN 103 - Management (no wifi)Everything worked fine until I activated clustering on both devices yesterday. Since then, I can't connect via ...

Ok, im using RV320, SG200-50, and 2xWAP320's, I'm trying to use captive portal on VAP2 ONLY (guest wifi) The IP will get passed to the guest device but will never go to the auth page HOWEVER if i use the VAP1 and set the instance association it works...