Hi,
I have a Cisco wireless router RV220W and a aironet 1041 access point.
I configure the aironet as an repeater but the problem is that the wireless router can't see the repeater (aironet). can anybody help me with this case???
many thanks,
Roger
Below you find the config file of the aironet configuration.
Current configuration : 1250 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname APCR2
!
logging rate-limit console 9
enable secret 5 $1$Ipk6$24lXe.WDBKxeONLPKNPZv.
!
no aaa new-model
!
!
dot11 syslog
!
dot11 ssid FENL01
infrastructure-ssid
!
!
!
username Cisco password 7 047802150C2E
username rdelacroix privilege 15 secret 5 $1$yE.c$RyGiK9NkxIRNPcp5aBqxX1
!
!
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
shutdown
!
ssid FENL01
!
antenna gain 0
parent 1 70ca.9b9a.30f0
station-role repeater
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface GigabitEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
no keepalive
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address dhcp client-id GigabitEthernet0
no ip route-cache
!
ip http server
no ip http secure-server
ip http help-path
http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
login local
!
end
