cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
462
Views
0
Helpful
2
Replies

SET VLAN ID WAP121

yaninabaeza
Level 1
Level 1

Hi,

I have a question about my cisco wap121. I did a change in the configuration of the VLAN ID management of my AP and after I did the change the AP is disconnected and can not connect to it again.

Anyone can help me about it.

 

Thank You.

2 Replies 2

Eric Moyers
Level 7
Level 7

My name Eric Moyers. I am an Engineer in the Small Business Support Center.

I am sorry to hear that you are experiencing this issue. 

When you change the management VLAN on the WAP that means only devices in that new VLAN ID will be able to manage the device.

What did you change it to? Also what is the management ID for the rest of your network? Can you please provide a brief overview of your network topology? Have you tried to factory reset and reconfigure.

Look forward to hearing your answers.

Eric Moyers
.:|:.:|:. CISCO | Cisco Technical Support | Wireless and Surveillance Subject Matter Expert

Please rate helpful Posts and Let others know when your Question has been answered.

Moin Ilyas
Level 4
Level 4

I'd agree to Eric. Also, try resetting to factory defaults.

Please share, if the issue has already been resolved?