10-12-2018 05:45 AM - edited 07-05-2021 09:17 AM
Hi,
I ran out of idea with this problem I have, I used to able to snmpwalk the full MIB tree on my Cisco 2500 wireless controller but I no longer can after a reboot on it WLC. I believe all the configs are fine, no error on snmp neither. I am able to snmpwalk it but getting below output, I am using snmp v2c.
.1.0 = No more variables left in this MIB View (It is past the end of the MIB tree)
(Cisco Controller) >show snmpversion
SNMP v1 Mode.................................... Disable
SNMP v2c Mode.................................... Enable
SNMP v3 Mode.................................... Disable
Any idea?
10-12-2018 06:18 AM
paste your snmp walk command, are you using v2 with snmpwalk ?
Verify the snmp configuration :
10-12-2018 07:15 AM
Hi Balaji,
Thanks for the fast respond and advice, I have checked through the settings from your link you sent up to the SNMPv3 part as we don't use it. Is it compulsory to put some config there even though it isn't enabled? Funny enough, my snmpwalk didn't work until I enabled snmp trap receiver. I use solawind snmpwalk, it's GUI based. This is how I use it, with snmp v2c:
Many thanks,
10-12-2018 07:32 AM
That is example to give you visualisation, what is to be configure.
if you are looking snmpv2 just enable only required and make changes accordingly?
so is that working ?
10-12-2018 08:34 AM
No it didn't work, I didn't change anything because my configs look correct comparing to your link.
I begin to think it is a bug, may be it isn't a config issue at all? Is there a setting to stop snmpwalk to read the full MIB tree on the wireless controller?
Thanks,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide