06-12-2012 06:41 PM - edited 07-03-2021 10:17 PM
Hi everyone, I have been racking my brain on this one all day. I have made some progress, but the AP just won't associate.
I have a 5508 WLC licensed for 100 APs. I have 1 - 1042 LAP connected for testing. I have DHCP configured for the AP, and it gets an address of 192.168.254.100/24 - the controller's management interface is 192.168.254.99/24. I can see that the AP is getting an IP and I can ping it from the controller. However, I simply do not see the AP associating. I enabled capwap debiugging and watched the events, but I didn't see anything crazy that clued me in. What am I doing wrong?
The controller is v6.0.199.4
Every time I have set these up in the past they have been pretty straight forward. I haven't gotten too deep into the config on the WLC becuase I don't want to cause more issues.
Thanks!
06-12-2012 07:01 PM
The controller is v6.0.199.4
Upgrade to 7.0.X.
Said so in the data sheet.
06-12-2012 07:02 PM
2 items ..
1 make sure your ap is a Lwapp model
2 upgrade your wlc to 7 code, 6 isn't supported
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: