Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2870
Views
0
Helpful
23
Replies

1140's not broadcasting N speeds

jlight80911
Level 1
Level 1

‎10-20-2009 06:55 AM - edited ‎07-03-2021 06:10 PM

Just purchased a few 1140 cisco AP's with a 2106 Lan Controller. Configured everything as stated by the manual and I can not connect at N speeds. We have two buildings, in the other building on the same network we have a 2006 Lan controller that has 4 1130's configured.

So my issue at hand right now is I am not able to connect at the N speed. Could this be an issue from mixed mode? I am a little confused on where to start.

Thank you,

Labels:
0 Helpful
23 Replies 23

Robert.N.Barrett_2
Level 4
Level 4

‎10-20-2009 07:34 AM

What is your WLAN config? You must be using WPA2/AES (or no encryption) to get the N speeds. Post a sanitized version of your controller config if you're not sure.

0 Helpful