12-11-2010 11:50 AM - edited 07-03-2021 07:32 PM
I'm new to Cisco dot11radio configurations.
Can someone please share the commands I would use to set the 2.4 and 5Ghz radios so that older laptops can see their SSID broadcasts and connect.
Thanks in advance.
Solved! Go to Solution.
12-12-2010 06:45 PM
configure these command and see if there is any improvement..
en
conf t
int dot11 0
preamble-short
no dot11 extension aironet
end
Lemme know if this helps..
Regards
Surendra
12-12-2010 07:02 PM
Bingo! Thanks!!
12-12-2010 07:07 PM
worked??
Lemme know if that answered your question
Regards
Surendra
12-12-2010 07:18 PM
surbg wrote:
configure these command and see if there is any improvement..
en
conf t
int dot11 0
preamble-short
no dot11 extension aironet
end
Lemme know if this helps..
Regards
Surendra
Yes--that worked!
Thanks very much for your help tonight.
12-12-2010 07:20 PM
Thats nice to hear!! and its my pleasure assisting you!
Good night!!
Regards
Surendra
12-12-2010 07:33 PM
Thanks for hanging in there with me on this! Good job!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide