cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
363
Views
0
Helpful
4
Replies
dcarr3311
Beginner

1240AG AP vty acl problem

All,

I have fat fingered an ACL on my VTY for an Autonomous 1240AG AP. So I am unable to SSH/telnet into the AP. I can however still HTTP into it. Is there a way to remove the VTY ACL from the web interface? or do I have to rest it?

Thanks for your help

Dan

4 REPLIES 4
Amjad Abdullah
Engager

If you have console access do it.

If you did not save acl config you can reload the ap.

Otherwise, I am not aware about any other way except resetting the config.

Amjad

Rating useful replies is more useful than saying "Thank you"

Hi Amiad

I figured it out. From the web interface if you go to System Software> System Configuration> Show tech-support> command.. you can add cli commands from there.

Thanks

Dan

Thank you.

I almost never used gui so don't know much about it :")

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"
fbarboza
Enthusiast

Hi,

If you still have access to the GUI (http) of the unit you can use the command http://AP ipaddress/exec and this will give you the option to go in and click on exce and run cli commands via the GUI.

Example:

xx.xxx.xx.xxx/level/exec

Content for Community-Ad