1240AG AP vty acl problem

[dcarr3311]

All,

I have fat fingered an ACL on my VTY for an Autonomous 1240AG AP. So I am unable to SSH/telnet into the AP. I can however still HTTP into it. Is there a way to remove the VTY ACL from the web interface? or do I have to rest it?

Thanks for your help

Dan

[Amjad Abdullah]

If you have console access do it.

If you did not save acl config you can reload the ap.

Otherwise, I am not aware about any other way except resetting the config.

Amjad

[dcarr3311]

Hi Amiad

I figured it out. From the web interface if you go to System Software> System Configuration> Show tech-support> command.. you can add cli commands from there.

Thanks

Dan

[Amjad Abdullah]

Thank you.

I almost never used gui so don't know much about it :")

Sent from Cisco Technical Support iPad App

[fbarboza]

Hi,

If you still have access to the GUI (http) of the unit you can use the command http://AP ipaddress/exec and this will give you the option to go in and click on exce and run cli commands via the GUI.

Example:

xx.xxx.xx.xxx/level/exec