01-13-2010 06:50 AM - edited 07-03-2021 06:25 PM
Hi Guys
I converted Autonomous AP 1252 to lwapp and it is registered with wlc but I take that ap on console its behaivour is like autonomous AP and
all lwapp command doesn;t work.
any one who can help me in this regard
thanks
01-13-2010 01:21 PM
When an LWAP has successfully joined a WLC all commands are disabled. It defeats the purpose as to why you want to configure an LWAP individually when it's being controlled by the WLC. You want to configure something for a particular LWAP, do it on the WLC.
01-13-2010 11:21 PM
yes You are right when lwapp join wlc no all command are disabled bydefault but this time all command are acceptable by AP like show running
show version, its behaviour is like autonomous AP but when I checked it on WLC 4402 where its status is lwapp and registered successfully.
I attached lwapp show run which you noticed its lwapp ios but all configuration is autonomous AP.
01-17-2010 01:23 PM
You can use some limited commands but one of the few commands you can't use is the "wr mem", "clear lwapp" or "lwapp". The reason is because the LWAP already runs the full CAPWAP IOS. If the LWAP is running the "rcv" image, the "clear lwapp" or "lwapp" command is enabled.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide