1542i Converting a CAWAP AP into a Mobility Express AP

[r_m]

Hello everyone
I followed the conversion procedure that I write below,

AP#ap-type mobility-express tftp://<TFTP Server IP>/<path to tar file>

with firmware : AIR-AP1540-K9-ME-8-7-102-0.tar

but the answer is as follows

############

Image transfer complete.
Image downloaded, writing to flash...
do CHECK_ME, part2 is active part
upgrade.sh: Error: image not found.
+ do_upgrade CHECK_ME
+ [ ! -r /tmp/part.tar ]
+ loudlog Error: image not found.
+ logger -p 0 -t upgrade Error: image not found.
+ echo upgrade.sh: Error: image not found.
upgrade.sh: Error: image not found.
+ return 1
+ status=1
+ set +x
Error: Image update failed.

##############

Has anyone had similar problems?

[Rasika Nayanajith]

I would try with other version 8.5.120.0 & see you face same issue ?

HTH

Rasika

[Leo Laohoo]

Alternatively, try this:  archive download-sw  tftp://<TFTP Server IP>/<path to tar file>

[r_m · Accepted solution]

Goodmorning everyone,
    the solution is to perform the conversion outside the class where the Controller Mobility Express is present and use the following command

ap-type mobility-express tftp: // <ip tftp server> / <path file .tar>

*** the error was just to perform the ap conversion in the same CME class.

once the following code is displayed

########################

Image transfer complete.
Image downloaded, writing to flash...
do CHECK_ME, part2 is active part
Image signing verify success.
AIR-AP1542I-E-K9
This is AP1542, use btldr_crete.bin.lzma/btldr_crete_md5 for uboot
Verify returns 0
Unlocking /dev/mtd4 ...
23+0 records in
23+0 records out
upgrade.sh: part to upgrade is part1
upgrade.sh: activate part1, set BOOT to part1
upgrade.sh: AP primary version: 8.7.102.0
Archive done.

#########################

restart the AP and move it to the class where the CME is present.

[reinaldotero]

Hi, when do you say the class do you referring to the network segment?

[amikoutsky]

He definitely, does.