11-16-2020 03:34 AM - edited 07-05-2021 12:47 PM
Hi all. I have a customer currently using Cisco 2702e with omni directional antennas. We are looking to replace some of these with directional antennas and therefore would like to survey.
I have surveyed before using Meraki which is really straight forward whenit comes to putting the AP into survey mode.
Is there a step by step guide on how to put a 2702e into survey mode? Is it done on the cli or the WLC?
Any help would be greatly appreciated.
Regards
11-16-2020 04:36 AM
Hi,
Here is the posts about to configure a Cisco AP for Site Survey:
https://thewlan.com.au/2016/09/27/configuring-a-cisco-ap-for-site-survey/
Regards
Dont forget to rate helpful posts
11-17-2020 06:56 AM
Hi Sandeep, I will give this a go. Thanks for your reply.
07-08-2021 11:49 AM - edited 07-14-2021 06:14 AM
I additionally endorse to use a expert corporation. Site surveys want enjoy and a few precise hardware to get truly useful effects. You can do it your self, for example with the mentioned Ekahau suite for new page, but revel in in doing it is also very crucial.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: