04-28-2014 12:12 PM - edited 07-05-2021 12:44 AM
Hi,
I'm trying to complete a factory reset on a WLC 4402.
Q: Is the 4402 factory reset procedure the same as the 5508:
>clear config
>reset system
Login as Recover-config
This 4402 has an old 9pin console port, so I've only been able to complete the first two items.
Does the service port have a default ip address and/or does it respond to dhcp servers?
Thanks.
Solved! Go to Solution.
04-28-2014 12:17 PM
Yes, procedure is same for 4402.
No, Service port does not have any default IP address. You have to get console access to configure it via initial script.
HTH
Rasika
**** Pls rate all useful responses. Each time you rate a response Cisco will donate $1 to Kiva ****
04-28-2014 12:17 PM
Yes, procedure is same for 4402.
No, Service port does not have any default IP address. You have to get console access to configure it via initial script.
HTH
Rasika
**** Pls rate all useful responses. Each time you rate a response Cisco will donate $1 to Kiva ****
04-28-2014 12:25 PM
Thanks. All that is needed is to wipe the previous config. Does completing the first two steps alone accomplish that or must one login as Recover-config?
04-28-2014 12:38 PM
Typically if you do not have login credentials (or password recovery), you would do "recover-config" as you can do this at login prompt (given that you do not know the password)
If you have done first two steps via SSH then you may not able to ssh again as your config was cleared. Try first two steps with console access & you should be prompted to initial script.
HTH
Rasika
**** Pls rate all useful responses. Each time you rate a response Cisco will donate $1 to Kiva ****
04-28-2014 04:13 PM
The command clear config
should be more than sufficient.
10-14-2018 05:43 PM
hi guys,
I've having major issues trying to pinout the console cable for the Cisco 4400 LAN controller, is there any stock standards connector or someone has the correct pinout for Cisco Console?
10-16-2018 02:00 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide