cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
388
Views
0
Helpful
2
Replies

4402 WLC & 1000 AP's

wmurphyccla
Level 1
Level 1

I'm trying to setup my wireless in a test environment before putting in my production just to verify I know how to set it up. Here is what I have: 3560 switch/POE, 4402 WLC, & a 1000 AP.

I plugged my AP into f0/1 of my switch and added it to VLAN 3. I assigned it an Ip address of 10.0.3.1

I setup G0/1 to trunk to port 1 of the WLC. Native vlan 1 with no ip address assigned.

On my WLC I setup a management port untagged assigned it IP address 192.168.1.184 with a gateway of 192.168.1.184.

I setup ap-manager untagged with an IP address of 192.168.1.185, gateway 192.168.1.184

I setup one interface "ccla_conf_net2" assigned it IP address 10.0.3.22 Vlan 3 with a gateway of 10.0.3.1

Lag is disabled so I assigned all interface's to port 1.

I can ping 10.0.3.22 and 10.0.3.1 but when I go into monitor on the WLC it's showing 0 AP's as being up. Plus my wireless laptop is not picking up the SSID "ccla_conf_net2"

Do you have any clues as to what I'm doing wrong??

2 Replies 2

jcornford
Level 1
Level 1

First suggestion is that you may have forgotton to configure your "ccla_conf_net2" as being capable of dynamic AP managment. Have you done that? Also, how did you get the IP address into the AP?

zhenningx
Level 4
Level 4

Why you configure the AP as the gateway of the dynamic interface? As my understanding, the gateway of the dynamic interface should be the routed interface of VLAN3.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: