4G LTE MIMO with EHWIC-4G-LTE

[Y. 'FoAmY' Vandenbossche]

Hey guys,

I'm looking at replacing the terrible DSL (1.5Mb/s) with 4G at my parent's place in rural France, I've got my old 1941 ISR with a 4G-LTE ehwic... I've tested the setup here in Belgium with the SIM from my cell and my config works just fine, I just have one question... I've read in the datasheet that 2x2 MIMO is supported by this card, however information / knowledge is a bit scarce online.

It looks like the antenna marked '0' is being used, but the one marked '1' doesn't appear to effect anything whether plugged in or not, this leads me to believe MIMO is not working. I'm assuming this requires some additional configuration but I can't find any guides. 

If anyone can help that would be much appreciated! 

-Yanni

[Y. 'FoAmY' Vandenbossche]

Hey guys,

I'm looking at replacing the terrible DSL (1.5Mb/s) with 4G at my parent's place in rural France, I've got my old 1941 ISR with a 4G-LTE ehwic... I've tested the setup here in Belgium with the SIM from my cell and my config works just fine, I just have one question... I've read in the datasheet that 2x2 MIMO is supported by this card, however information / knowledge is a bit scarce online.

It looks like the antenna marked '0' is being used, but the one marked '1' doesn't appear to effect anything whether plugged in or not, this leads me to believe MIMO is not working. I'm assuming this requires some additional configuration but I can't find any guides. 

If anyone can help that would be much appreciated! 

-Yanni

[Arshad Safrulla]

Can you post an output for show cellular 0/0/0 all, check the Current RSSI(RSCP) =-XX

Assuming you have very good Meanwhile you can also configure "cell 0/0/0 lte technology UMTS or lte" to make sure that the higher speed protocols are always preferred. This will make sure that gsm is always ignored.