cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
682
Views
0
Helpful
2
Replies

5508 1142 H-Reap anyone?

danletkeman
Level 1
Level 1

Hello,

Does anyone have a 5508 controller with 1142's setup in H-Reap mode with wpa2/aes/psk authentication?

No matter what configuration i try I cannot get a client connected if the access point is communicating with the controller. As soon as I disable/block the access point from communicating with the controller, the client can connect.

Has anyone else come across this problem? Could anyone else verify the same thing I have?

Thanks,

Dan.

2 Replies 2

didyap
Level 6
Level 6

An 1142 access point in hybrid-REAP mode sometimes enters stand-alone mode. If the access point is rebooted while in stand-alone mode, the 802.11a radio changes to a different channel than the one configured by the controller after a few minutes.

Very odd problem, but after i restarted the controller everything started working as it should.

Dan.

Review Cisco Networking for a $25 gift card