Re: 7920 Fast Secure Roaming with WDS - Page 2

rsmusolino · ‎03-17-2004

Does anyone know when the 7920 will support Fast Secure Roaming with WDS?

michaelgillespie · ‎07-21-2005

Would need to set the 7920 authentication mode to AKM, enter LEAP username/password info and have a similiar AP config below, where the AP is communicating to a WDS:

dot11 ssid voice

authentication network_eap eap-methods

authentication key-management cckm

!

interface dot11radio 0

ssid voice

encryption vlan 1 mode ciphers wep128

!

wlccp ap username wds password cisco

dazilk · ‎08-10-2005

We have just implemented FSR/WDS using 7920 phones on a network consisting of 25 1200 series APs. So far, roaming between APs appears to be completely transparent. Previously the users were experiencing 1-5 second delays when roaming.

This technology looks like a winner!

michaelgillespie · ‎08-10-2005

You must have had network delays to the radius server then as LEAP should only take up to 300ms.

dazilk · ‎08-10-2005

Actually each AP was configured as a local RADIUS server, so there should be no network delays. I suspect that the delays might have been caused by a significant signal overlap, but am not sure.