Hi,
I am trying to configure the Access Point module on my Cisco Router (897AVW), however I am unable to route / ping between the router and the AP.
In a few examples I've seen, the wlan-GigabitEthernet interface has the command:
switchport trunk allowed vlan 1-3,1002-1005
or
switchport trunk native vlan 2
I have tried both and although the router doesn't error, show-ing the config, neither commands have taken.
Is there something I am doing wrong or is this a bug in the IOS?
To save making this post long, my latest running configs are on my blog:
Router: http://www.thingsgeeky.walker.uk.com/?p=3781
AP: http://www.thingsgeeky.walker.uk.com/?p=3781
Many Thanks
W.
