9120AXI Access Point

[NaveenG_Wi-Fi]

Hi,

I have access points ( 9120AXI-E model ) registered on 9800-LC wireless lan controller. I would like to enable SSH on the APs and  I am unable to find the option on the WLC, like we have on other models of WLC. Any inputs?

Regards,

N

[d.friday]

The SSH setting should be under the AP Join Profile 

AP Join Profile
The default AP join profile values will have the global AP parameters and the AP group parameters. The AP join profile contains the following parameters – CAPWAP, IPv4 and IPv6, UDP Lite, High Availability, Retransmit config parameters, Global AP failover, Hyperlocation config parameters, Telnet and SSH, 11u parameters, and so on.

[NaveenG_Wi-Fi]

Hi @d.friday 

Thanks, I found the setting under AP Join Profile. It seems to be like a global setting, I am looking to enable SSH selected APs, please advise.

Thanks,

N

[linchuanyang]

Dear All

Do you know the detailed hardware information about the Catalyst 9120AXI (e.g. cpu processor, ect.)? From the data sheet, we know that the memory is 2048 MB DRAM and 1024 MB flash.

Thank you.

Antony

[patoberli]

I don't have one, but on the older models it's printed in the boot up log on the console port.