ā10-23-2024 10:24 PM - edited ā10-23-2024 10:25 PM
Hello Team,
Team is there an requirement for 9130 ap's should be connected on ten gigabit ethernet .
Regards,
Anjana
Solved! Go to Solution.
ā10-23-2024 10:52 PM
Multigigabit Ethernet support |
Multigigabit Ethernet provides uplink speeds of 5 Gbps and 2.5 Gbps, in addition to 100 Mbps and 1 Gbps. All speeds are supported on Category 5e cabling, as well as 10GBASE-T (IEEE 802.3bz) cabling. |
ā10-23-2024 10:52 PM
Multigigabit Ethernet support |
Multigigabit Ethernet provides uplink speeds of 5 Gbps and 2.5 Gbps, in addition to 100 Mbps and 1 Gbps. All speeds are supported on Category 5e cabling, as well as 10GBASE-T (IEEE 802.3bz) cabling. |
ā10-23-2024 11:47 PM
need some clarity:
if the number of connected users increses than normal will it cause user disconnection if the ap is connected in gigabit ethernet port?
We are encountering the error like client PMKID mismacth.
is it related to the interface utilization also FT is enabled in wlan
Regards,
Anjana
ā10-24-2024 12:10 AM
- I don't think PMKID mismatch is related to AP usage and load ; more likely bug(s)
Include controller model and software version being used ,
M.
ā10-24-2024 01:36 AM
controller 9800-L:
AP:9130-Flex mode
WLC:17.9.5
Regards,
Anjana
ā10-24-2024 01:52 AM
- There are a number of bugs which could be related in https://bst.cloudapps.cisco.com/bugsearch?pf=prdNm&prdNam=Cisco%20Catalyst%209800%20Series%20Wireless%20Controllers&kw=PMKID&bt=custV&sb=anfr
Therefore and since 17.9.x is EOL I would advise to upgrade 17.12.4 ,
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide