9130-ap requirement

[Anjana A]

Hello Team,

Team is there an requirement for 9130 ap's should be connected on ten gigabit ethernet .

Regards,

Anjana

[marce1000 · Accepted solution]

 - Ref : https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9100ax-access-points/nb-06-cat-9130-ser-ap-ds-cte-en.html
  >...

Multigigabit Ethernet support

Multigigabit Ethernet provides uplink speeds of 5 Gbps and 2.5 Gbps, in addition to 100 Mbps and 1 Gbps. All speeds are supported on Category 5e cabling, as well as 10GBASE-T (IEEE 802.3bz) cabling.

[Anjana A]

need some clarity:

if the number of connected users increses than normal  will it cause user disconnection if the ap is connected in gigabit ethernet port?

We are encountering the error like client PMKID mismacth.

is it related to the interface utilization also FT is enabled in wlan

Regards,

Anjana

[marce1000]

 - I don't think PMKID mismatch is related to AP usage and load ; more likely bug(s)
   Include controller model and software version being used , 

 M.

[Anjana A]

controller 9800-L:

AP:9130-Flex mode

WLC:17.9.5

Regards,

Anjana

[marce1000]

  - There are a number of bugs which could be related in https://bst.cloudapps.cisco.com/bugsearch?pf=prdNm&prdNam=Cisco%20Catalyst%209800%20Series%20Wireless%20Controllers&kw=PMKID&bt=custV&sb=anfr

    Therefore and since 17.9.x is EOL I would advise to upgrade 17.12.4 ,

  M.