07-11-2024 10:21 PM
Hi all,
I'm trying to setup a 9800CL without any vlan. I can set it up and get an IP while using vlan1 from my DHCP server but for some reason I cannot see NASes when I connect my MacBook to the AP connected to the 9800. I can connect to them if I go to Finder>Connect to Server and enter the smb:// address. I really don't care if I have vlan1 up and my network devices are populated, that would work too. I just have no need for vlans on this network so everything is on the same subnet.
Thanks!
07-12-2024 01:11 AM - edited 07-12-2024 06:01 AM
- Your plan looks 'worry some' since already the device management and the Wireless Management Interface need a separate VLAN. You may always checkout all configuring attempts on the controller with the CLI command
show tech wireless and feed the output from that into Wireless Config Analyzer
M.
07-21-2024 06:00 AM
Your problem is more likely to do with mDNS than VLANs...
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/technical-reference/c9800-best-practices.html#Multicast
https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/215352-configure-and-troubleshoot-mdns-on-catal.html
https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/9800/17-3/deployment-guide/c9800-mDNS-technical-guide-rel-17-3.pdf
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-12/config-guide/b_wl_17_12_cg/m_mdns_gateway.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide