Access Point in Workgroup Bridge Mode

[t.piening]

Which actual Access Point (18xx; 28xx; 38xx; IWxxx) can be configured as an Workgroup Bridge like the old 1702 (EOS) ?

[Sandeep Choudhary]

Hi,

These APs"18xx; 28xx; 38xx" can not be used as WGB

Check this feature matrix:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-7/b_feature_matrix_for_802_11ac_wave2_access_points.html

Regards

Dont forget to rate helpful posts

[Feichti · Accepted solution]

Your right but in the new 8.8MR2 Beta there is a new Feature added:
WGB on COS Aps
Mesh Support on All Indoor/Outdoor wave APs including ME
BLE Dongle Solution
4K SSID Scale

i havent tryied this.
You can request access to the Beta via the following Link:
http://cs.co/88Mr2InterimAccess

Regards