cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
183
Views
0
Helpful
1
Replies

access wlc froma network defined on the wlc

alessandro.dona
Level 3
Level 3

Hi Guys,

i have a wlc 2504 with 7.6.130

My management ip address is 192.168.1.1/24 and i have an interface on the wlc with ip address 192.168.2.1

From a PC(wired) with ip address 192.168.2.x (network are routed) i cannot access https://192.168.1.1 when i configure on the wlc an interface with ip address 192.168.2.1

It's look like i cannot access wlc from a network defined on the wlc.

Can you help me in resolving this issue?

1 Accepted Solution

Accepted Solutions

Stephen Rodriguez
Cisco Employee
Cisco Employee

That is by design. The WLC does not allow access from a configures interface other than management by default. 

 

If you need to access the WLC from a configures interface other than management you need to issue the command:

config network mgmt-via-dynamic-interface enable

 

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

That is by design. The WLC does not allow access from a configures interface other than management by default. 

 

If you need to access the WLC from a configures interface other than management you need to issue the command:

config network mgmt-via-dynamic-interface enable

 

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Review Cisco Networking products for a $25 gift card