cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
97
Views
0
Helpful
1
Replies
Highlighted
Participant

access wlc froma network defined on the wlc

Hi Guys,

i have a wlc 2504 with 7.6.130

My management ip address is 192.168.1.1/24 and i have an interface on the wlc with ip address 192.168.2.1

From a PC(wired) with ip address 192.168.2.x (network are routed) i cannot access https://192.168.1.1 when i configure on the wlc an interface with ip address 192.168.2.1

It's look like i cannot access wlc from a network defined on the wlc.

Can you help me in resolving this issue?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

That is by design. The WLC does not allow access from a configures interface other than management by default. 

 

If you need to access the WLC from a configures interface other than management you need to issue the command:

config network mgmt-via-dynamic-interface enable

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered

View solution in original post

1 REPLY 1
Highlighted

That is by design. The WLC does not allow access from a configures interface other than management by default. 

 

If you need to access the WLC from a configures interface other than management you need to issue the command:

config network mgmt-via-dynamic-interface enable

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered

View solution in original post

Content for Community-Ad