01-09-2013 07:02 PM - edited 07-03-2021 11:19 PM
Hi,
I am just wondering what happens when you add in a new Mesh AP e.g 1500 series AP to an existing working Mesh network.
If the Bridge Group Name of the mesh network is ABC and we add a new Mesh AP in, will it work out of the box?
By default the BGN of a mesh AP is set blank (I think), how can you configure it when the BGN is different?
If the BGN is different, it wont join the WLC through the RAP correct?
Thanks
Solved! Go to Solution.
01-09-2013 07:09 PM
It will not join.. You would need to have it join the wlc via an Ethernet connection and then set the BGN.
Sent from Cisco Technical Support iPhone App
01-09-2013 07:09 PM
It will not join.. You would need to have it join the wlc via an Ethernet connection and then set the BGN.
Sent from Cisco Technical Support iPhone App
01-09-2013 07:15 PM
Hi Scott,
Thanks for the reply, so you would have to pre-configure it on the WLC via LAN first and make sure the BGN is the same before deploying it out as a mesh ap?
Thanks
01-09-2013 07:10 PM
Make sure to add the MAC address also.
Sent from Cisco Technical Support iPhone App
01-09-2013 07:17 PM
Yes that is correct
Sent from Cisco Technical Support iPhone App
01-09-2013 07:18 PM
Thanks
01-09-2013 07:19 PM
No problem
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: