cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
220
Views
0
Helpful
2
Replies
Highlighted
Beginner

Adding Vlans to trunk from 6513 to WiSM2

HI,

 

I need to add 2 new vlans to the trunk between the WiSM2 and the 6513 chassis. The WiSM is in slot 13 of the chassis and I want to ensure that adding the new Vlans won't disrupt the current connections.

 

Thanks,

 

Waqas

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Just 1 thing to note, adding a vlan to a trunk is a non service effecting change and should not cause issues but you have to remember your stp and if by set by default will be using pvst on the 6513 so there will be a layer 2 calculation for that vlan,if just 1 trunk it should go straight to fwd but if multiple there may be a slight calculation to prevent any loop but this should not be noticed by end users, always good to have a small maintenance window in case something goes array anyway but in general nothing wrong should happen just make sure the add part is in the command or you will over write the current trunk config 

View solution in original post

2 REPLIES 2
Highlighted
VIP Mentor

Just 1 thing to note, adding a vlan to a trunk is a non service effecting change and should not cause issues but you have to remember your stp and if by set by default will be using pvst on the 6513 so there will be a layer 2 calculation for that vlan,if just 1 trunk it should go straight to fwd but if multiple there may be a slight calculation to prevent any loop but this should not be noticed by end users, always good to have a small maintenance window in case something goes array anyway but in general nothing wrong should happen just make sure the add part is in the command or you will over write the current trunk config 

View solution in original post

Highlighted

Thanks Mark